A single or double glass door in an office partition: hinges, a lock or latch set and a pull handle, on glass that has already been cut to a drilling drawing.
Interior & Commercial Glass Doors
Hinged glass doors in office partitions and commercial interiors.
What an order for this scenario runs on
Commonly specified glass thicknesses
- 10 mm
4 product lines specified into this scenario
The scenario
What buyers run into
Specification mismatch. The hardware has to match both the glass thickness and the hole centres the glass was cut to, and the door is in constant daily use.
How to specify this scenario
Confirm the glass thickness and hole centres first, then the hinge type, the locking requirement (keyed or keyless) and the handle length. A drawing, or a photo of the existing fitting with its measurements, tells us more than a description.
Typical configuration
The parts this scenario is usually built from
- Hinges
- Matched to the glass thickness and hole centres.
- Lock or latch set
- Keyed or keyless.
- Pull handle
- Back-to-back or single-sided.
Load and safety
10 mm is the thickness most office glass doors and interior partitions are made in. The fitting is machined for one thickness and cannot be adapted afterwards.
Installation notes
Check the parts against the glass before drilling, and work from the drawing supplied with the model you ordered rather than from the fitting that came off.
Common mistakes
Matching a part from a photo alone.
A photo without the glass thickness, the panel size and the fixing distance can lead to the wrong model.
How to avoid: Send the numbers with the photo.
Fixing hardware ordered for a different glass thickness.
The fitting is machined for one thickness and cannot be adapted.
How to avoid: Check the parts against the glass before drilling.
Product lines specified into this scenario
Shower Hinges
Hinges for glass-to-wall and glass-to-glass shower enclosures, including hydraulic soft-close models.
Door Handles
Pull handles for frameless glass doors, back-to-back or single side.
Door Knobs & Locks
Knobs and lock sets for glass doors, locking or non-locking, in the finish your market sells.
Sliding Door Rollers
Rollers and hanging sets for sliding glass doors, in the configurations your system uses.
Where to go next
Direct inquiries
Need immediate technical specifications or a quotation?
Send your drawings, models, quantities and destination port. Our Foshan export engineering team replies within 24 working hours.